Knowledgebase
I have the FB1014 foundation kit. I have the foundation together, but I am concerned that I might have it upside down. The instructions say to make sure the holes are to the center, but it looks like the holes are on the bottom in the picture. if they ar
Posted by Elite Deals - Chris M. on 20 November 2013 10:50 AM

Our Answer:

The channeling that makes up this foundation kit should be positioned so that the channel opening faces down - similar to the letter "n". The center facing holes listed in the manual refer to the holes in the tabs at the ends of the 10192 lengths. These tabs are intended to be bent down and dropped into the 10192 lengths running across the length of the shed floor.

In Response to Question:

I have the FB1014 foundation kit. I have the foundation together, but I am concerned that I might have it upside down. The instructions say to make sure the holes are to the center, but it looks like the holes are on the bottom in the picture. if they are on the bottom, how do you pull out the plywood on it? Tthere must be a reason they say to put holes toward the center! I know to use drywall screws, but where do they go? Please help me understand how to proceed with this.

From Page: Arrow Outdoor Shed Foundation Kit - 10 X 12 or 10 x 14 - FB1014

Manufacturer's Product Number: FB1014

Our SKU: ARW-FB1014

Page ID: arshfokit10x

(0 vote(s))
Helpful
Not helpful