Knowledgebase
I have a wood burning fireplace. When it is windy outside and we have a fire burning, we get puffs of spoke that come into our living room. The serial number in the fireplace is DESA WB056653. Our chimney is a dual-wall, cylindrical chimney with 8 inch
Posted by Elite Deals - Chris M. on 24 October 2013 03:30 PM

Our Answer:

This cap should press right into your factory pipe with no problem. However, you'll want to confirm with your fireplace's installation manual that a cross-section of 50.3 square inches is an adequate vent opening.

In Response to Question:

I have a wood burning fireplace. When it is windy outside and we have a fire burning, we get puffs of spoke that come into our living room. The serial number in the fireplace is DESA WB056653. Our chimney is a dual-wall, cylindrical chimney with 8 inch diameter inner cylinder and a 12 inch diameter outer diameter. The current chimney cap is attached to the outer cylinder (the 12 inch one). It is a cylinder with mesh on the sides with a flat circular plate on top. This looks like the cap that we need. Can you please confirm that I'm picking the right one?

(0 vote(s))
Helpful
Not helpful