Knowledgebase
I will need to know the exact height, width and depth dimensions of both the Reduced Clearance Blower Kit and the Regular Blower Kit for the Napoleon 1600C Wood Stove. We have already purchased the 1600C stove and will have a tight installation, and are
Posted by Elite Deals - Chris M. on 24 October 2013 03:47 PM

Our Answer:

Per Napoleon, the EP65 is the blower kit by itself. The EP63 is the blower kit and the rear heat shield that is needed to install the blower. If you already have the heat shield installed, you will only need the EP65 blower. If there is not shield on the stove, the EP63 will need to be specified, in order to receive the needed shield. Both blowers are built into the rear heat shield and do not add any additional depth to the stove. The shield itself reduces clearances from the stove to the back wall by 8 inches. If you are using single wall pipe, there must be 25" from the flue pipe to the wall. If you are using double wall, you can cut this number down to 18". Both blower kits would need to be special ordered for you.

In Response to Question:

I will need to know the exact height, width and depth dimensions of both the Reduced Clearance Blower Kit and the Regular Blower Kit for the Napoleon 1600C Wood Stove. We have already purchased the 1600C stove and will have a tight installation, and are not sure which blower kit will fit properly.

(0 vote(s))
Helpful
Not helpful